Furnaces & heating

Furnace Not Working? 7 Checks Before You Call

Homeowner in a sweater checking the wall thermostat in a cold house on a snowy day

It’s cold, the house is getting colder, and the furnace is silent. Before you book a repair, these seven quick checks solve a surprising number of no-heat calls. Some of them take less than a minute.

Safety first. If you smell gas (a rotten-egg smell), don’t touch light switches or appliances. Get everyone out and call Enbridge Gas at 1-866-763-5427 or 911 from a safe place. If your carbon monoxide (CO) alarm sounds, get everyone outside and call 911. Skip the checks below until it’s safe.

1. Check the thermostat

Make sure it’s set to Heat (not Off, Cool or Fan only), and that the set temperature is a few degrees above room temperature. If it runs on batteries and the screen is blank or dim, replace them. Smart thermostats can also be stuck on a schedule, an “away” mode or a Wi-Fi hiccup, so check the app.

2. Check the power

A furnace needs electricity even if it burns gas. Look for:

  • the furnace service switch, which usually looks like a regular light switch on or near the furnace. It’s easy to flip off by mistake;
  • a tripped breaker in your electrical panel. Reset it once. If it trips again, stop and call us.

3. Look at the filter

A badly clogged filter can choke airflow until the furnace overheats and shuts itself off as a safety measure. Slide it out. If it’s grey and caked, replace it (note the size printed on the frame). It’s one of the most common causes of a furnace that runs briefly and then quits.

4. Clear the outside pipes after snow

Most high-efficiency furnaces in Ottawa have two plastic pipes, an air intake and an exhaust, that exit through a side wall. After a big snowfall, drifting or an ice build-up, these can get blocked, and the furnace will shut itself off. Gently clear snow and ice from around them. Don’t pull on or bend the pipes.

5. Make sure the furnace door is on properly

Many furnaces have a safety switch that stops the furnace from running if the front panel isn’t seated correctly, for example after a filter change. Press the panel firmly into place.

6. Check the condensate drain

High-efficiency furnaces produce water that drains through a small tube to a floor drain or a little condensate pump. If the pump is full or broken, or the line is blocked or frozen, many furnaces will shut down. Look for water pooling around the furnace or a pump that’s full and not running.

7. Read the status light

Many furnaces have a small window with a blinking light. The blink pattern is a code, explained on a sticker inside the panel door. Write it down or snap a photo. It helps us diagnose faster. Avoid resetting the furnace over and over. If it keeps locking out, there’s a reason that needs a technician.

When to stop and call a pro

Call us if you’ve done the checks above and still have no heat, or if you notice any of these:

  • the breaker trips again after one reset;
  • burning, electrical or unusual smells;
  • banging, squealing or rattling noises;
  • water leaking from the furnace itself (not just a full condensate pump);
  • the furnace blows cold air, or turns on and off every few minutes;
  • the furnace is old and this keeps happening (see what a new furnace costs).

Keeping warm safely while you wait

Close blinds and curtains, close doors to unused rooms, and use safe, certified electric space heaters kept well clear of anything that can burn. Never use an oven, barbecue, generator or other fuel-burning device to heat your home. These can produce carbon monoxide, which is invisible and odourless (Government of Ontario). Ontario’s Fire Code requires CO alarms next to each sleeping area in homes with fuel-burning appliances, a fireplace or an attached garage. Since January 1, 2026, they’re also required on every storey (ontario.ca). Now is a good time to test yours.

How to avoid the next no-heat night

  • Change or check the filter regularly, more often in winter, if you have pets, or during renovations.
  • Book a yearly furnace check-up before the cold sets in. It covers ignition, safety controls, venting and airflow. See furnace maintenance.
  • Keep the outside pipes clear all winter. Make it part of your shovelling routine.
  • Test your CO alarms monthly, and check batteries and expiry dates twice a year, as Enbridge recommends (Enbridge Gas).
  • Consider a smart thermostat that can alert your phone if the house gets too cold while you’re away. See thermostats and controls.

What to tell us when you call

To help us arrive prepared, have these handy: the furnace’s make and approximate age (often on a sticker inside the panel), any blinking-light code, what you’ve already checked from the list above, and whether anyone at home is especially vulnerable to the cold. Call 613-862-5551.

What a TempZone no-heat call costs

  • Mon–Fri 9 AM–5 PM: $150 + tax service call. Urgent no-heat calls during regular hours are billed as a regular service call. It includes the diagnosis and a repair quote before any work begins.
  • Evenings, weekends and holidays (24/7): $300 + tax emergency call, with priority dispatch when available.

See our 24/7 emergency HVAC and furnace repair pages. To avoid the next surprise, a yearly tune-up is the easiest fix. See maintenance. We cover all of Ottawa, including Barrhaven, Nepean, Kanata and Orléans.

Frequently asked questions

Why is my furnace blowing cold air?

Common causes include the thermostat fan set to “On” instead of “Auto”, a dirty filter, ignition problems, a limit switch fault or airflow restrictions. If basic checks don’t fix it, book a diagnostic.

Why does my furnace turn on and off every few minutes?

Short cycling can come from a clogged filter, blocked vents or intake/exhaust pipes, a thermostat problem or an oversized furnace. If it continues after you change the filter and clear the pipes, call us.

Is no heat an emergency?

In an Ottawa winter it can be, especially with babies, seniors or anyone vulnerable at home, or if pipes could freeze. We offer 24/7 emergency service. After-hours calls are $300 + tax.

How much is a furnace repair visit?

A service call is $150 + tax Mon–Fri 9 AM–5 PM, including the diagnosis and a quote before work. Evenings, weekends and holidays are $300 + tax. Parts and repairs are quoted before we start.

Who do I call if I smell gas?

Leave first, then call Enbridge Gas at 1-866-763-5427 or 911 from a safe place. For a CO alarm, get out and call 911.

Sources

Sources last checked October 2026. Programs, rules and prices change; always confirm on the official website.

Need help? Call 613-862-5551 or book online. Regular hours Mon–Fri 9 AM–5 PM · Emergency service 24/7.

‹ Back to the blog

Call Book